Bow and Stern Pulpits and Stanchions

To post a question or a response or to pass along a tip that has worked for you on your Nor'Sea, please send an e-mail to the Webmaster at marbeth@ix.netcom.com.

Important note: The information here is not warranted. Each writer has contributed his or her own opinions and experience for the benefit of other Nor'Sea owners and does so with the caveat that should you have difficulties implementing these suggestions or as a result of using them, the writer accepts no blame nor offers any warranty or redress. Please proceed at your own risk.

All material here is used by permission. They may be printed out for your own use. They may not be printed out for others or for distribution, however; if you wish to use them for this purpose, separate permissions must be obtained from each writer. Thank you for observing copyright protection.


Stainless Steel Parts
by Frank Hooper, #16 (fghooper@ix.netcom.com
I have included price quotes from RailMakers in Newport Beach, Calif., for various stainless steel items. RailMakers is Bob Eeg's supplier.

Contact Dave at:
Railmakers, Inc.
864 West 18th Street, Costa Mesa CA. 92627
Phone 714-842-6506 Fax 714-842-8066

Nor'Sea items are COD plus freight charge via MasterCharge or Visa

bow rail $510
stern rail $215
stern with traveler $380
forward gate $63
aft gate $92
stanchion $27
stove bar $65

Be careful, though, as measurements could be a bit different from the original equipment. The designs have changed over the years; best you send drawing and measurement for quote; then have a confirming fax back from them to insure the numbers are right. For example, I widened the area on the stern rail I ordered so that I had more tiller room. Dave will also make boomgallows stanchions.


Please address comments or questions about this web page to the Webmaster at marbeth@ix.netcom.com. Last updated October 1, 1997.